INSTRUCTIONS FOR:
REVERSE ACTION WHEEL
STUD THREAD RESTORER KIT
MODEL No: SX203
Thank you for purchasing a Sealey Product. Manufactured to a high
standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are
adhered to when using tools.
DO NOT use thread restorer if damaged.
Maintain thread restorer in good and clean condition for best and safest performance.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
Follow vehicle manufacturers warnings, cautions and service procedures.
Ensure that the vehicle being worked on is adequately supported on axle stands. Do not support vehicle on
jack alone.
1. SAFETY INSTRUCTIONS
3. OPERATING INSTRUCTIONS
2. INTRODUCTION & SPECIFICATION
3.1 Choose the correct sized split die for the thread to be restored.
3.2 Stretch the die apart, manoeuvre it over the damaged thread and
allow it to close over the good part of the thread at the back of
the stud.
3.3 Place the adaptor over the wheel stud and rotate it until the two
pins within the adaptor pass into the apertures between the two
halves of the die so that the die is entirely enclosed within the
adaptor.
3.4 Place a 29mm socket onto the hex part of the adaptor and attach
a suitable driving tool. A 'T' bar arrangement would be ideal.
3.5 Rotate the tool anti-clockwise to draw the die up the thread
towards the damaged area. Continue turning anti-clockwise to
restore the thread, occasionally backing off a quarter turn to clear
the die. Continue the process until the die comes off the thread.
3.6 Test the thread by carefully screwing on a wheel nut.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
sales@sealey.co.uk
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version
SX203 Issue: 1 - 29/06/10
Unique design allows for the two halves of the thread restorer to be tted on the good thread and wound back
over the damaged thread, normally at the end of the stud. Traditional thread restorers rely on luck for the restored
and undamaged threads to align. Kit contains the three most common wheel stud thread sizes. Supplied in
storage case.
Thread sizes: 12 x 1.25mm, 12 x 1.5mm, 14 x 1.5mm. Adaptor Holder: 29mm Hex Drive
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals