Sealey LED2105 User Manual download pdf

INSTRUCTIONS FOR

CORDLESS 21+5 RECHARGEABLE INSPECTION

LAMP LITHIUM-ION

MODEL NO: LED2105

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY

1.1. GENERAL

 Ensure the lamp is fully charged before initial use.

 DO NOT turn the lamp on when it is being charged.

 DO NOT shine directly into your, other person’s or animal’s eyes.

 DO NOT allow children to use the lamp.

 DO NOT handle or move the lamp whilst it is being charged.

 DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.

DO NOT LEAVE BATTERY IN A DISCHARGED STATE, RECHARGE BATTERY IMMEDIATELY. BEFORE STORAGE, FULLY

RECHARGE THE BATTERY, SUBSEQUENTLY RECHARGE THE BATTERY AT LEAST ONCE EVERY SIX

MONTHS OF NON-USE.

1.2. ELECTRICAL SAFETY FOR USE OF CHARGER.

USE ONLY THE SUPPLIED CHARGER PLUG FOR CONNECTING LAMP TO THE POWER SUPPLY.

R WARNING! It is the user’s responsibility to read, understand and comply with the following electrical instructions:

You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.

An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD

(Residual Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical

supply not protected by an RCCB.

You must also read and understand the following instructions concerning electrical safety.

1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualied

electrician, using a Portable Appliance Tester (PAT), at least once a year.

1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and

the safety of the appliance operator. If in any doubt about electrical safety, contact a qualied electrician.

1.2.3. You must ensure that you:

 Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the mains power

supply.

 If worn or damaged DO NOT use.

V Important: Check that the voltage marked on the charger plug is the same as the lamp.

 Uncoil the cable between charger and the lamp.

 DO NOT pull the charger plug from the mains socket by the lead.

R WARNING! DO NOT use any other type of charger with this product, other than the supplied mains or car charger. Failure to observe

this warning could result in injury and or re and will invalidate the warranty.

 DO NOT try to take the charger plug apart.

 DO NOT use the charger plug to charge or power any other electrical item.

 DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).

1.3 BATTERY SAFETY

R WARNING! To reduce the risk of burns or re:

 DO NOT Attempt to open, disassemble, modify or service the battery pack.

 DO NOT Crush, puncture, short external contacts or dispose of in re or water.

 DO NOT Expose to temperatures above 60°C (140°).

 Replace only with the battery pack designated for this product.

 Recycle or dispose of used battery as stipulated by local regulation.

If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool

water and seek immediate medical attention

2. INTRODUCTION

Model No’s LED2105, LED2105F, LED2105G and LED2105UV feature 26 super bright LEDs and Model No. LED3010 features 35 super

bright LEDs for use as inspection lamps. All models have 5 LEDs in the end for use as a directional torch. Model No. LED2105UV has ve

Ultra Violet LEDs for fault nding with uorescent dyes used in leak detection. Single LED battery indicator. Two 360° swivel hanging hooks for

hands-free applications. Three rubber covered magnets, two magnets on the rear of the lamp and one on the end. Bottom quarter of the lamp

rotates 180°. Replaceable shatterproof polycarbonate lens with a highly polished reector board gives an increased spread of light. Lithium-ion

polymer battery for longer life, no memory effect and a much slower discharge than typical Ni-MH batteries. Supplied with mains and in-car

chargers. Model No. LED2105 available with Schuko plug, add EU to Model No.

3. SPECIFICATION

Model No: ............................................................... LED2105

Charging Time: ................................................................4hrs

Operating Time: ..............................................................4hrs

LED2105 | Issue 3 17/03/15

Original Language Version

1 2 3

Summary of Contents

Page 1 - LAMP LITHIUM-ION

INSTRUCTIONS FORCORDLESS 21+5 RECHARGEABLE INSPECTION LAMP LITHIUM-IONMODEL NO: LED2105Thank you for purchasing a Sealey product. Manufactured to a hi

Page 2 - 6. MAINTENANCE

4. CHARGING V IMPORTANT WARRANTY INFORMATION: the battery tted to this cordless tool is considered to be a consumable item and its ability

Page 3 - 01284 703534

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior

Comments to this Manuals

No comments

Sealey LED2105 User Manual

Browse online or download User Manual for Lighting Sealey LED2105. Sealey LED2105 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Sealey LED2105