Sealey AP1200R User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4.11 See Fig.13. Now start to build the second low level unit by
making up two end frames as shown in Fig.14. One short 'Z'
beam (C) should be fixed at the top of the angle posts and
the other short 'Z' beam (C) should be fixed at the 7th and
8th keyholes up from the bottom of the angle posts as shown
below. Ensure that each 'Z' beam is facing upwards. Tap the
beam at either end, close to each angle post to ensure that
the rivets are seated at the bottom of the keyhole slots.
4.12 See Fig.14. Join the two end frames together using the
four remaining long 'Z' beams as shown above. Ensure
that each 'Z' beam is facing upwards. Tap the beams at
either end, close to each angle post to ensure that the rivets
are seated at the bottom of the keyhole slots.
4.13 See Fig.15. Lay the shelves into position between the 'Z'
beams as shown above.
4.14 See Fig.16. Place the two units end to end as shown below
and join them together using the 2 post clips (F). Insert a
post cap (E) into the top of each 'A' post.
01284 757500
01284 703534
sales@sealey.co.uk
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
email
4.10 HALF HEIGHT STORAGE STATION. See Fig.12. Follow
steps 4.2 and 4.3 to create a bottom frame with four 'A' posts
attached. Using two long 'Z' beams (B) and two short 'Z'
beams (C) insert a shelf support level at the top of the angle
posts (A). Tap the beams at either end, close to each angle
post to ensure that the rivets are seated at the bottom of the
keyhole slots. Insert another shelf support level at the desired
height within the frame using additional long and short 'Z'
beams and ensure that the rivets are seated at the bottom of
the keyhole slots.
Fig.12
Fig.13
Fig.15
Fig.14
Fig.16
AP900R, AP1200R Issue: 1 - 05/06/09
Page view 3
1 2 3 4

Comments to this Manuals

No comments