Sealey AK716 User Manual download pdf (Page 2)

5. OPERATION

5.1. Slide Hammer

5.1.1. Before using the required attachment disassemble and grease as shown in g.1. Reassemble.

5.1.2. Insert the attachment into the bearing, see g.2

5.1.3. Hold the attachment with a spanner and wind the drive pin into the attachment with another spanner until the jaws open and grip the

bearing.

5.1.4. Screw the attachment/drive pin onto the slide hammer, see g.3.

5.1.5. Hold the bearing puller and slide the hammer towards the bearing and then quickly back to the other end of the shaft. Repeat until

the bearing has been removed.

5.1.6. Make sure the bearing is being pulled out evenly. If not remove the puller attachment and softly tap the bearing back in with a soft

faced mallet, until it is seated squarely. Then reattach the tool and pull the bearing out.

5.1.7. Release the bearing by undoing the drive pin from the attachment.

5.2. Bridge Extractor

5.2.1. Before using the required attachment disassemble and grease as shown in g.1.

5.2.2. Insert the attachment into the bearing.

5.2.3. Hold the attachment with a spanner and wind the drive pin into the attachment, with another spanner, until the jaws open and grip the

bearing.

5.2.4. Place the bridge extractor legs in the correct position over the bearing housing, tighten the cap head screws screws on the legs to

hold them in position.

5.2.5. Screw the bridge extractor’s hex screw into the attachment. Hold the attachment with a spanner and tighten.

5.2.6. Hold the long cap head screw still and wind the bearing out using the nut beneath.

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.

IMPORTANT: No liability is accepted for incorrect use of this product.

WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.

Sole UK Distributor, Sealey Group.

Kempson Way, Suffolk Business Park,

Bury St. Edmunds, Suffolk.

IP32 7AR

www.sealey.co.uk

sales@sealey.co.uk

01284 757500

01284 703534

Web

AK716.V2 | Issue 1 03/03/15

Original Language Version

g.2

g.4

g.3

g.1

Environmental Protection

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be

sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.

When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)

into approved containers and dispose of the product and the fluids according to local regulations.

1 2

Comments to this Manuals

No comments

Sealey AK716 User Manual Page 2

Comments to this Manuals

Related products and manuals for Tools Sealey AK716