Sealey AK714 User Manual download pdf

INSTRUCTIONS FOR:

BLIND BEARING PULLER SET - 5PC

MODEL No: AK714.V2

2. INTRODUCTION

1. SAFETY

3. CONTENTS

26mm - 32mm Attachment (Part No: AK714.V2-01)

20mm - 25mm Attachment (Part No: AK714.V2-02)

Slide hammer (Part No: AK714.V2-03)

15mm - 20mm Attachment (Part No: AK714.V2-04)

11mm - 15mm Attachment (Part No: AK714.V2-05)

 WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are

adhered to when using this product.

 DO NOT use this product if damaged.

 Maintain product in good and clean condition for best and safest performance.

 If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.

 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.

 Wear suitable clothing to avoid snagging. Do not wear loose jewellery and tie back long hair.

 Account for all tools and parts being used.

 If working off the vehicle, secure the work piece in a vice or clamp it to a work bench.

 DO NOT operate puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.

 IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or a proprietary manual, to

establish the current procedure and data. These instructions are provided as a guide only.

2.1. Introduction

Fully chromed carbon steel medium stroke slide hammer. 370mm Overall length with 1.4kg hammer. Bearing

extractor collets with internal capacity from 11 to 32mm. Supplied in carry-case.

Original Language Version

AK714.V2 Issue No.1 06/11/09

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these

instructions and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.

USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE

AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1 2

INSTRUCTIONS FOR:BLIND BEARING PULLER SET - 5PCMODEL No: AK714.V2 2. INTRODUCTION 1. SAFETY 3. CONTENTS26mm - 32mm Attachment (Part No: AK714

4. INSTRUCTIONS4.1. Prior to use of the required attachment, disassemble and grease as shown in fig.1. Reassemble the attachment.4.2.

No comments

Sealey AK714 User Manual