Sealey AP6572 User Manual download pdf (Page 3)

AP6572 & AP6572E ISSUE 5(A) 19/07/13

EXTENSION PACK

MODEL NO: AP6572E

1.0 We recommend that this extension unit be

assembled by two people. The only tool

required is a rubber mallet. DO NOT use a

hard faced hammer as this will damage the

surface finish of the cross beams. Make sure

that all the clips lock in place securely before

using the unit. DO NOT use any parts that are

damaged and/or distorted as these may

assemble incorrectly and result in an

installation that is unsafe and which may cause

injury or damage when the shelves are loaded.

2.0 See Fig.A. Support one end frame 'A' in a

vertical position and attach the end of one

cross beam 'B' to it at the base of one of

the uprights. Ensure that both tags on the end

brackets engage properly with the slots in the

uprights as shown in the inset diagram. Tap the

cross beam gently next to the end bracket so

that the beam is properly seated into the slots

in the upright. Connect the other end of the

beam to the existing racking unit at the same

height and tap into place.

3.0 Attach another cross beam 'B' to the other side

of the end frames 'A' ensuring that it is at the

same level as the first cross beam. Attach 4

smaller cross beams 'D' between the main

cross beams 'B'.

4.0 See Fig.B. Continue to assemble the next

three pairs of cross beams at the heights

required. The end frames allow adjustment in

3" increments. Each pair of beams must be

mounted at the same height. Ensure that all

tabs on the cross beam brackets are fully

engaged in the slots in the uprights and that

the cross beams are properly tapped down into

place.

5.0 See Fig.C. Each wire deck 'C' is reinforced

with four cross members welded onto the

underside of the mesh. Each of these cross

members has a turned down tab at either end

that must pass through slots in the cross

beams. Place a wire deck onto each pair of

cross beams as shown ensuring that it sits into

the recessed section on the top surface of

each cross beam and all tabs pass through the

slots in the cross beams as shown in the inset

diagram at the top of Fig.C.

Fig.A

Fig.B

Fig.C

Carefully unpack the product and check the

contents against the list below. Should any

items be missing or damaged make immediate

contact with your Sealey dealer.

Part Description ..................................Qty.

A Upright Frame ............................................1

B Cross Beam (Long) ....................................8

C Wire Mesh Shelves ....................................4

D Cross Beam (Short) .................................16

Original Language Version

1 2 3

Comments to this Manuals

No comments

Sealey AP6572 User Manual Page 3

Comments to this Manuals

Related products and manuals for Equipment Sealey AP6572