MK67.V2
3.1 Remove either the upper or lower paper bar from the frame by
unscrewing and removing the black knobs at either end.
3.2 Loosen the screw in one of the black plastic retaining rings and
remove the ring, spring and washer from the end of the bar.
Remove the cardboard tube centre of the last roll from the bar.
3.3 Slide the the paper bar through the centre of the new paper roll
and refit the washer, spring and retainer to the end of the bar.
Temporarily tighten the screw in the black retaining ring.
3.4 To refit the loaded bar to the frame get a second person or
persons to support the paper roll while the black knobs are fitted
at either end of the bar. The paper should be coming off the top
of the roll. Once loaded, check that the roll is centrally placed on
the paper bar and make any necessary adjustments using the
black retaining rings.
3.5 Push a roll of masking tape onto each tape
dispensing reel and spin it to make sure the
tape is running true. Check that the tape
dispensers are aligned with the ends of of
the paper roll as shown in Fig.4. (The
centre line of the tape should align with the
edges of the paper roll). The position of the
tape dispensers can also be adjusted as
shown in Fig.3. To increase or decrease dimension ’X’ loosen the
wing nut ‘Z’ and roll nut ’Y’ up or down the bolt as required.
Retighten the wing nut.
3.6 Pull about 18” of paper from the roll and feed it between the
paper spring and the back edge of the adjacent paper cutter.
3.7 Pull tape from each dispenser in turn and stick it to the paper roll
so that it is half on and half off the paper edges. Check the
alignment of the tapes and make any further adjustments
required to the positions of the tape dispensers.
3.8 Slowly pull the paper from the roll and check that the tapes feed
correctly onto the edges of the paper.
3.9 Tear the paper off with an upward movement against the down
facing teeth of the paper blade. Keep hands well away from the
blade when doing this.
3.10 Load the other paper bar as described above.
NOTE: A fully loaded frame is quite heavy. Take care when
moving it and always leave it in a stable position.
Fig.2
Fig.4
Fig.3
3. USING THE DISPENSERS
01284 757500
01284 703534
sales@sealey.co.uk
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
email
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
MK67.V2 Issue No: 1 - 26/08/08
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals