3. CERAMIC ELEMENTS
DO NOT touch an element just after switching ‘off’ power supply. Allow to cool.
Ensure that the heating elements are:
• Free of fractures and cracks and are of good general condition.
• Maximum of 1400W each.
WARNING! There are no user serviceable components inside this heater, if an element requires replacing please return to an authorised
Sealey dealer.
2. INTRODUCTION & SPECIFICATION
Portable powder coated metal construction with two ceramic heating ele-
ments provide instant heat when required. Polished reflectors maximise the
heat emission. Output is controlled by rocker switches fitted to the frame.
Carry handle allows for safe movement whilst in use. Sturdy legs provide a
secure base. Supplied with 2m cable fitted with 32Amp/110V
rated plug.
Min. Power: 1400W
Max. Power: 2800W
Input supply: 110V 32A
Heater Dimns.(W x D x H): 360 x 370 x 555mm
Weight: 6.5kg
4. OPERATION
Fig.1
Heater Identification Fig.1
1) Heater Element 5) Power on Neon
2) Safety Guard 6) Power On/Off
3) Heater Body 7) Stand
4) Handle
Original Language Version
CH28110V Issue: 2(l) - 12/06/15
4
1
2
6
5
7
3
© Jack Sealey Limited
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before
using the heater.
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary
shocks or vibration and is not moved when it is on or until cooled down.
4.1 Ensure the heater is at least 2m from any object.
4.2 Plug in the heater and switch it on.
4.3 The heater has the following settings: See (Fig.2).
Position 0:0 Off position.
Position I:0 Upper element only.
Position 0:I Lower element only.
Position I:I Both elements.
4.4 When the heater is no longer required, switch off and unplug the unit.
IMPORTANT: DURING RELOCATION, THE HEATER SHOULD REMAIN SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY.
In the event of the heater being knocked over, a safety cut-out switch, which activates at an angle of 35º ±10º,
will disable the heater.
Follow these steps to re-start the heater.
a) Switch ‘off’ the heater at the on/off switches. As (Fig.2).
b) Disconnect the power cord from the power supply.
c) Return the heater to a standing position.
d) If no damage has occurred to elements, replace safety guard if applicable, re-connect power cord to the
power supply and switch the heater back on.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a
suitably qualified person.
Off
Off
On
On
Fig.2
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals