Sealey POWERMIG6025S User Manual

INSTRUCTIONS FORPOWERMIG WELDERSPOWERMIG6025SPOWERMIG6035SMODEL No's:POWERMIG6025S, POWERMIG6035S Issue: 2(L) -06/03/14 © Jack Sealey L

11. TROUBLESHOOTINGPROBLEM POSSIBLE CAUSEREMEDY (Numbers refer to chapter and item heading)1. Power source stops Overheating protection activated due

1.3 GENERAL SAFETY The operator should be properly trained to use the welder safely and should be informed about the risks relating to mig and ar

2. INTRODUCTION & SPECIFICATIONSTried and trusted by fabricators and professional car repair shops across the UK. Superb quality, heavy-duty el

4. UNPACKING & CONTENTS 5. ASSEMBLY & INSTALLATION4.1 UNPACKING Due to the weight of these welders it is a four man job to unpack them

5.2.6 Connect to main welder. Connect the other end of the umbilical extension cable to the main welder as shown in fig.3. 5.2.7 Firstly connect

6.1 The wire feed mechanism has two separate grooved drive rollers and two separate pressure rollers. The pressure rollers are in separate hou

6.7 FEEDING WIRE THROUGH TO THE TORCH.6.7.1 Before feeding the wire through to the torch the gas cup and contact tip should be removed as shown i

IMPORTANT. Should you have no welding experience, we recommend you seek training from an expert source to ensure your personal health & safet

9.4 COMMENCING WELDING. 9.4.1 Before carrying out difficult sections of welding, tests should be carried out on scrap pieces of metal. These tes