Sealey VS0286 User Manual download pdf

VS0286 - Issue: 2 - 23/09/10

INSTRUCTIONS FOR:

BRAKE WIND-BACK

TOOL KIT 29pc

MODEL NO:

VS0286

2. INTRODUCTION

Air operated wind back tool suitable for left or right hand wind back operations. Fast, lightweight and easy to use. Master set of

adaptors suit a wide range of vehicle applications. Suitable for push-back and wind-back brake pistons. Left-handed thrust required

for Ford, Citroen and Renault applications. Interchangeable adaptor plates with thrust bolt assembly and reaction plate. Includes

3/8”Sq drive adaptor and 2-pin magnetic adaptor for added flexibility. Kit helps prevent damage to pistons and seals.

 WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to

when using tools.

 DO NOT use tools if damaged or worn.

 Maintain the tools in good and clean condition for best and safest performance.

 Ensure all threads are clean and well lubricated.

 Ensure vehicle is adequately supported with axle stands, ramps, etc. as appropriate.

 Wear suitable clothing to avoid snagging. Do not wear jewellery. Tie back long hair.

 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.

 Account for all tools and parts being used and do not leave them in or on the vehicle.

IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or proprietary manual, to establish the correct

procedure and data. These instructions for use are provided as a guide only.

 WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible

conditions and situations that may occur. It must be understood that common sense and caution are factors which

cannot be built into this product, but must be applied by the operator.

1. SAFETY INSTRUCTIONS

g.2

3. SET UP & OPERATION

3.1 Set Up

3.1.1 Removethewindbacktoolfromthecarrycaseandtthe3/8"adaptor(5).

3.1.2 Selecttheappropriateadaptorusingtheapplicationchart(overleaf,Section5),attachthistothe3/8"adaptor.

3.1.3 Selectthecorrectcalliperplateandattachthistothewindbacktool.(g.2)

3.1.4 Connect an air supply to the air inlet on the bottom of the tool using

 therecommendedsetupright(g.1).

3.1.5 Settheregulatoronthecompressorto90PSI.

3.2 Operation

3.2.1 Squeeze trigger to apply pressure on the calliper piston.

3.2.2 When applying pressure on the piston turn the wind back handle to

rotate and compress the piston; the handle can be turned

either way depending on the design of the calliper.

3.2.3 Pushthepressurereleasebuttontoretractthetool.

g.1

4. MAINTENANCE

4.1 Lubricate the tool daily with a few drops of sealey air

tool oil dripped into the air inlet. Lightly oiling the wind

back shaft will prolong the life of the tool.

4.2 After use clean the tool with a damp cloth and mild

detergent to remove any dirt and grime.

4.3 Whenyouarenishedwiththetoolstoreitinadry,

safe, childproof location.

1 2

Summary of Contents

Page 1 - MODEL NO:

VS0286 - Issue: 2 - 23/09/10INSTRUCTIONS FOR:BRAKE WIND-BACK TOOL KIT 29pcMODEL NO: VS0286 2. INTRODUCTIONAir operated wind back tool sui

Page 2 - 01284 757500

01284 75750001284 [email protected] UK DistributorSealey Group,Bury St. Edmunds, Suffolk.www.sealey.co.ukWebemailNOTE: It is our policy to

Related models: VS0288 | RE99/09 | RE99/10 | PS982 | HP10 | HP5 | PS990 |

Comments to this Manuals

No comments

Sealey VS0286 User Manual

Browse online or download User Manual for For the car Sealey VS0286. Sealey VS0286 User Manual

Summary of Contents

Related models: VS0288 | RE99/09 | RE99/10 | PS982 | HP10 | HP5 | PS990 |

Comments to this Manuals

Related products and manuals for For the car Sealey VS0286